This is the multi-page printable view of this section. Click here to print.
For AVR, you’ll need to 3D print some parts for your drone. While not needed immediately, these are good to get started with:
Explore each of the subsections to see what you’ll need to print.
To download parts select the download button.
Onshape Download Button
Change the units from Meters to Millimeters.
Onshape Units Selection
The export page should resemble the following. Press OK.
Onshape Export Page
For the landing gear it is highly advised that you print with 100% infill as these are going to be parts that will need to withstand the impact of landing.
Additionally, you should print the mounts vertically for increased strength. This puts the layers perpendicular to most of the forces applied rather than parallel.
Recommended mount printing orientation
An infill of 15% should be sufficient for these parts.
For best prints, it is advised that you rotate the part onto its back for printing.
Zed Mini Standard Orientation
Zed Mini Print Orientation
An infill of 15% should be sufficient for these parts.
This bracket goes on the front of the Tello to prevent it from getting stuck in the AVR net.
Tello Cage Bracket